Put the following in the Bustools.ini file (located in your System folder) to prevent the Bus Monitor from running when...
There are two methods for setting status bits in the 1553 status word. BusTools_RT_AbufWrite: Set the status word for...
Share
The top window shows how to configure the application using Tornado. First, you need to remove the -ansi directive. Then...
Share
Prior to contacting Condor technical support, download the attached file 'cei_probe.zip' (under 'Attachments', below)...
Share
The following may be used to connect to the 68-pin connector on the CEI-520: 3-foot, 68-pin SCSI cable: MFR: Dynamic...
Share
A PA-100 running under Windows NT 4 may display the message "No UART Found". This is because our API currently does not...
Share
Installing the QPMC-1553 in a VxWorks system is a two part process: Modify the VxWorks image to configure the QPMC-1553...
Share
You can test your board by running Test Config as follows: First, make sure you can initialize the board. On a single...
Share
Condor does not support interrupts on the VME-1553 under Linux. However, it is not difficult to create your own...
Share
While it is possible for two executables to manipulate the two IP modules independently, there is a startup...